3D PRINTER MANUAL- RAISE3D PRO2 SERIES
- 28-
www.raise3d.com
The distance between the nozzle and the
printing platform can be adjusted by turning
the thumb screw on the left-front corner of
the Z-plate, the higher the screw stands out,
the further the distance between the nozzle
to the printing platform becomes.
Insert the USB storage that contains your
sliced model (.gcode and .data files).
Insert this USB drive into the USB slot on the
side of touchscreen.
Select the “Print” tab, and choose “USB
Storage”. Select the file and check the printing
parameters and settings. Press “Print” to start
printing the test file.
During printing, you can check the status of
your print including printing time remaining
and other parameters from the touchscreen in
the “Home” interface.
NOTE: The touch screen will display an image
of your model on-screen during printing. This
image will only be shown when the file is
sliced by ideaMaker and the .data file is saved
in USB storage or uploaded to screen.
To Next Page
Loading...
