81
Inserting a USB key into port 20 (g. 3) will automatically upload the LOAD & SHOW interface, through which
it is possible to perform the following operations:
software updating procedures.
uploading of any static or dynamic customisation logos**.
updating of the machine messages (provides new language
upload options).
enables uploading of another machine’s parameters or downloading
parameters - currently in use on Class 10.
Note:
The les that need to be uploaded must be copied directly onto the USB key, without rst putting them into
a folder.
Never switch the machine off during the upload procedure.
** Features of the logos that can be
uploaded
Static logo
Up to 4 static logos can be displayed on the Class
10.
In order to be uploaded into the machine system, the
logos must have the following features:
- bitmap image (.bmp)
- 240x64 pixel resolution
- 2-colour image (1 bit)
One animated logo can be displayed on the Class
10.
In order to be uploaded into the machine system, said
logo must have the following features:
- bitmap image (.bmp)
- Max. 1280x64 pixel resolution
- 2-colour image (1 bit)
W23 Interr. EV cold 4-TEA
W24 EV hot 4-TEA shorted
W25 Interr. EV hot 4-TEA
W26 EV steam iSteam shorted
W27 Interr. EV steam iSteam
W30 EV air iSteam shorted
W31 Interr. EV air iSteam
W32 Check the message le
W33 Check USB
To Next Page
Loading...
