R&S ZNA50 - Page 372

GUI reference
R&S
®
ZNA
372User Manual 1178.6462.02 ─ 20
2 Tone Delta Freq.
Allows you to select the frequency delta between upper tone and lower tone.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:APERture
Mixer Delay
The controls in this section allow you to configure and perform a mixer delay calibra-
tion.
Mixer Dly Cal ← Mixer Delay
Performs the mixer delay calibration.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:ACQuire
Use Constant Cal Dly ← Mixer Delay
If checked, you can specify a constant calibration delay. Otherwise you can use the
"Variable Cal Dly" button to pick a CSV file with delay data for the reference mixer.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CDMode
Constant Cal Dly/Variable Cal Dly ← Mixer Delay
If Use Constant Cal Dly is checked, you can enter a constant calibration delay. Other-
wise the button is labeled "Variable Cal Dly" and you can click on it to load delay data
for the reference mixer from a CSV file.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CDELay
MMEMory:LOAD:MDAData
Mixer Dly Cal Active ← Mixer Delay
Activates or deactivates an available mixer delay calibration (performed using Mixer
Dly Cal).
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CORRection[:STATe]
5.2.15.2 Two Tone Group Delay setup dialog
The "Two Tone Group Delay" dialog is an example of a Chapter 4.2.2.3, "Multi-channel
setup dialog", on page 112. It allows you to prepare one or more channels for two-tone
group delay measurements (with or without embedded LO).
Access:Trace – [Meas] ("Mixer Params") > "Two Tone Group Dly" > "Setup Frequency
Converting DUT"
Meas softtool