R&S ZNA50 - Page 843

GUI reference
R&S
®
ZNA
843User Manual 1178.6462.02 ─ 20
More preset options are available via the Presets tab of the "System Config" dialog.
Preset
Executes the configured preset action. See "Normal / RF Off / Normal, GUI, Ext Setup /
<File Name>" on page 843.
Normal / RF Off / Normal, GUI, Ext Setup / <File Name>
These radio buttons allow you to select between different preset modes, i.e. the deter-
mine the functionality of the Preset button and the System – [Preset] hardkey (if Imme-
diate Preset is enabled).
"Normal"
Factory preset.
"RF Off"
Factory preset + RF Off All Channels
"Normal, GUI,
Ext Setup"
Factory preset + GUI reset actions (all of Reset Colors / Reset Dia-
logs / Reset Decimal Places / Reset Units Prefix) + reset RF connec-
tion configuration between VNA and external devices.
Currently, the latter only resets the frequency converter configuration.
"<File Name>"
User preset file.
If another preset action is active, the button is labeled "File". Click the
button to select a recall set file to be used as user preset file and acti-
vate it (same as Select Preset File...). The button then displays the
file name.
The Preset Scope can be configured in the "Presets" tab of the "System Config" dialog.
Remote command:
SYSTem:PRESet:MODE
Immediate Preset
Deactivate this checkbox to disable the preset functionality of the System – [Preset]
hardkey and let it open the "Select Preset" softtool tab only. The selected preset action
must be triggered using the Preset button then.
Preset softtool