R&S ZNL4 - Page 966

Command reference
R&S
®
ZNL/ZNLE
966User Manual 1178.5966.02 ─ 20
[SENSe<Ch>:]SWEep:TIME........................................................................................... 969
[SENSe<Ch>:]SWEep:TIME:AUTO..................................................................................970
[SENSe<Ch>:]SWEep:TYPE...........................................................................................971
[SENSe<Ch>:]SWEep:COUNt <Sweep>
Defines the channel-specific number of sweeps to be measured and buffered in single
sweep mode (INITiate<Ch>:CONTinuous OFF). Use [SENSe:]SWEep:COUNt:
ALL to define the sweep count for all channels.
Suffix:
<Ch>
.
Channel number
Parameters:
<Sweep> Number of consecutive sweeps to be measured and buffered.
Range: 1 to 100000
*RST: 1
Example: See CALCulate<Chn>:DATA:NSWeep:FIRSt?
Manual operation: See "Sweeps" on page 344
[SENSe:]SWEep:COUNt:ALL <Sweep>
Defines the number of sweeps to be measured in single sweep mode
(INITiate<Ch>:CONTinuous OFF). The setting is applied to all channels. Use
[SENSe<Ch>:]SWEep:COUNt to define the sweep count for a single channel.
Setting parameters:
<Sweep> Number of consecutive sweeps to be measured.
Range: 1 to 100000
*RST: 1
Example: See Chapter 11.6.2.4, "Data handling", on page 1071.
Usage: Setting only
Manual operation: See "Sweeps" on page 344
[SENSe<Ch>:]SWEep:DWELl <MeasDelay>
Defines the "Meas. Delay" before each partial measurement or the first partial mea-
surement (see [SENSe<Ch>:]SWEep:DWELl:IPOint). Setting a delay disables the
automatic calculation of the (minimum) sweep time (see [SENSe<Ch>:]SWEep:
TIME:AUTO).
Suffix:
<Ch>
.
Channel number
VNA command reference