WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
26
Pressure Testing
Connect the appliance to the gas supply. Check the appliance
is gas sound.
The gas pressure can be measured at one of the hotplate
injectors. Lift o a burner head. Fit the pressure gauge to the
jet. Turn on and light one of the other burners with a match.
Turn on and press in the control knob for the burner with the
pressure gauge tted.
The pressure should be 29mbar for Butane and 37mbar for
Propane.
After checking the pressure, turn o the taps and replace the
burner head.
Reassemble burner top, making sure it is reassembled in the
correct way on the burner body.
n
Check the appliance is gas sound.
n
Check operation of all the burners.
Assembly of gas supply and leakage
check
Connect the appliance in accordance with applicable local
and international standards and regulations. First, check what
type of gas is installed on the cooker.
This information is available on a sticker on the back of the
cooker. You can nd the information related to appropriate
gas types and appropriate gas injectors in the technical
data table. Check that the feeding gas pressure matches the
values on the technical data table, to be able to get the most
ecient use and to ensure the minimum gas consumption.
If the pressure of used gas is dierent than the values
stated or is not stable in your area, it may be necessary to
assemble an available pressure regulator on the gas inlet. You
should contact an authorised service centre to make these
adjustments.
To Next Page
Loading...
