Initial start-up
8 / 107
Please read the manual carefully prior to initial start-up.
During initial start-up of your new appliance, you will be requested to start an automatic one-
off self-test. This self-test takes about 45 minutes and is used to adapt the appliance to the
specific environmental conditions. Please note the following:
- For the self-test to be carried out, all the packaging materials must be have been removed
from the appliance; check the grid shelves and the air baffle for a correct fit.
- The appliance must be connected in accordance with the installation instructions.
- For appliance sizes 6 x 2/3, 6 x 1/1, 10 x 1/1, 6 x 2/1 and 10 x 2/1 GN place a flat GN
container with the opening facing downwards into the centre of the grid shelves.
- For the appliance size 20 x 1/1 and 20 x 2/1 GN place two GN containers in the mobile
oven rack. Place one flat GN container with the opening facing downwards in the centre
in front of both the upper and lower fan wheel.
- For further details please follow the instructions shown on the display and the installation
manual.
Risk of fire!
Remove the packaging material, starter kit as well as grids and containers.
The cooking chamber door must not be opened during the self-test. Opening the cooking
chamber door will lead to failure of the self-test. Restart the self-test by switching the appliance
off. Always allow a hot appliance to cool down first. If the test is interrupted you will be
requested next day by the appliance to start the self-test again.
step info/button instructions
To Next Page
Loading...
Need help?
General
