Windows
28
Advanced setting items as shown above are as follows.
[Delay time between power on and SCSI bus reset]
Default value is 0. You can set delay time for some SCSI devices which hang
up if SCSI bus reset is issued right after the FR1SX gets powered. Set this
value to 2 for Castle Wood ORB drive, Canon FB620S or Sharp JX-370.
[Delay time between SCSI bus reset and SCSI command]
Default value is 1. You can set delay time for some SCSI devices which hang
up if SCSI command is issued right after SCSI bus resets.
To Next Page