Ratoc Systems FR1SX - 5-10.Write Error Happens on Castlewood ORB; 5-11.Castlewood ORB Can Not be Recognized When You Start Your Computer with ORB Connected; 5-12.CD-R;RW Writing Software Can Not Recognize; But,The Macos Recognizes the CD-R;RW

55
5-10.Write error happens to Castlewood ORB(Win/Mac)
The AC adapter the Castlewood ORB uses may not be able to provide enough
termination power for the FR1SX to work. You should purchase an OPTINAL
AC adapter. Refer to Chapter 7.
5-12.CD-R/RW writing software can not recognize the
CD-R/RW drive connected to the FR1SX. But,the
MacOS recognizes the CD-R/RW (Mac)
The writing software you are using may not be able to treat FireWire interface.
You have to use the writing software which can treat FireWire or install B’s
Crew SIM driver. Refer to Chapter 2-4 for the driver information.
5-11.Castlewood ORB can not be recognized when you
start your computer with ORB connected(Win/Mac)
Set 2 seconds at [Delay time between power on and SCSI bus reset] with
the SCSI configuration utility. For more information, refer to section B in
Chapter 4-1-2(Windows users), section B in Chapter 4-2-1(MacOS9.x users),
or section B in Chapter 4-2-2(MacOS X users).