Macintosh
36
Advanced setting items as shown above are as follows.
[Target SCSI ID.]
Default value is AUTO. You can set target SCSI ID No.
[Enable parity check]
Default value is enabled. You can set parity check enable or disable.
[Delay time between power on and SCSI bus reset]
Default value is 0. You can set delay time for some SCSI devices which hang
up if SCSI bus reset is issued right after the FR1SX gets powered. Set this
value to 2 for Castle Wood ORB drive, Canon FB620S or Sharp JX-370.
[Delay time between SCSI bus reset and SCSI command]
Default value is 1. You can set delay time for some SCSI devices which hang
up if SCSI command is issued right after SCSI bus resets.
To Next Page