Macintosh
42
[SIM Driver mode] This setting is usually checked(Enalbed). This item is
only for MacOS 9.x.
[Speed] Default value is 20MB/s.You can set Max transfer rate from 20, 10
,5MB/s, Async.
[Parity check]
Default value is enabled. You can set parity check enable or disable.
[FireREX1/FR1SX SCSI ID] FR1SX SCSI ID is No. 7.
[SCSI bus reset]
Default value is enabled.You can set whether the FR1SX issues SCSI bus
reset to a SCSI device or not.
[Target SCSI ID.]
Default value is AUTO. You can set target SCSI ID No.
[Enable START/STOP UNIT command]
Default value is disabled. You have to enable START UNIT command for
some SCSI devices which will not work if they does not receive this START
UNIT command.
To Next Page