Rauch AXIS H EMC Series - Notes on Text Descriptions; Instructions and Procedures; Listings; References

User instructions 2
4
2.3 Notes on text descriptions
2.3.1 Instructions and procedures
Steps that the operator must carry out are shown as a numbered list.
1. Instruction for action step 1
2. Instruction for action step 2
Instructions involving only one step are not numbered. The same applies for ac-
tion steps that do not have a specific sequence.
A bullet is placed in front of these instructions:
 Handling instruction
2.3.2 Listings
Listings without a specific sequence are shown with bullet points (level 1) and
dashes (level 2):
 Property A
- Point A
- Point B
 Property B
2.3.3 References
References to other text passages in the document are indicated with section
number, headline text and page number:
 Example: See also Chapter 3: Safety, page 5.
References to other documents are indicated as note or instruction without exact
chapter or page number:
 Example: Please also observe the instructions contained in the manual for
the universal drive shaft.