Rauch AXIS H EMC Series - Setting the Disc Speed; Spreading Fertiliser Preconditions

Spreading operation
83
8
8.7 Setting the disc speed
8.8 Spreading fertiliser
8.8.1 Preconditions
Before starting the work, ensure that all preconditions for a secure and econom-
ically reasonable spreading are fulfilled.
Particular attention is to be paid to the following points:
 Are the tractor and machine safe for operation?
 Are there persons present on the machine or in the spreading area? Instruct
them to leave the hazard zone.
 Do the environmental conditions allow for hazardless spreading? Particular
attention is to be paid to excessive wind speed.
 Do you know the terrain and are you aware of potentially hazardous spots?
 Are you using the correct fertiliser?
 Have you entered the desired application rate at the control unit, in the fertil-
iser setting menu?
 Has the hydraulic system of the tractor been switched on?
 Spreading can be started.
NOTICE
Take the correct disc speed from the fertiliser chart and enter the value at the
machine operating terminal.