Rauch AXIS H EMC Series - Installing the Machine on the Tractor

Commissioning 7
44
7.3 Installing the machine on the tractor
7.3.1 Preconditions
Check the following specific requirements:
 Are both the tractor and the machine in a reliable condition?
 Does the tractor comply with the mechanical, hydraulic, and electrical require-
ments?
- See “Tractor requirements“ on page 43
.
 Do the attachment categories of the tractor and the machine match (if neces-
sary, consult your dealer)?
 Is the machine securely positioned on level and solid ground?
 Do the axle loads conform to the stipulated calculations?
- See “Axle load calculation“ on page 37
Position of the distance washers (only for AXIS H 50.2 EMC, category III)
Ensure the correct position of the distance washers [2] included in the scope of
delivery on each side of the lower link ball [1].
Figure 7.1: Position of the distance washers when installing the machine
(AXIS H 50.2 EMC, category III)
n DANGER
Danger to life due to inattention or faulty operation.
There is a crushing hazard that may result in fatal injury for per-
sons standing between the tractor and the machine when the trac-
tor approaches or the hydraulic system is actuated.
The tractor may brake too late or not at all because of inattention
or faulty operation.
 Ensure that nobody is present in the hazard zone between
the tractor and the machine.
1
2