Maintenance and repair 9
112
If the mark is not aligned to the string, the drop point must be readjusted.
n WARNING
Danger of crushing and shearing due to components operat-
ed by an external force
When working on power-operated components (adjusting lever,
metering slides), there is a crushing and shearing risk.
Pay attention to the shear point of the metering slide opening and
the metering slide during all adjustment work.
Switch the tractor motor off.
Remove the ignition key.
Disconnect the power supply between the tractor and the
machine.
Never actuate the hydraulic metering slide during adjust-
ment work.
1. Attach a suitably thin string
at the rear in the direction of
travel (as shown) to the low-
er sides of the left and right
adjustment centres and taut-
en it.
Figure 9.17: Attaching the string to the ad-
justment centre
2. The triangular mark on the
adjustment centre must co-
incide with the tensioned
string.
Figure 9.18: Markings on the adjustment
centre
NOTICE
For adjustment of the drop point settings, please contact your dealer or an au-
thorised specialist workshop.
To Next Page
Loading...
