Commissioning 7
54
3. If the lifting height of the tractor is insufficient for setting the required mounting
height: use the lower coupling point on the lower link of the machine.
Figure 7.9: Machine mounted to the lower coupling point of the lower link
The following applies:
NOTICE
Make sure that the maximum admissible length specified by the upper link or
tractor manufacturer is not exceeded.
Please observe the instructions in the operator’s manual provided by the
tractor and upper link manufacturer.
AXIS H 30.2 EMC
AXIS H 30.2 EMC + W
AXIS H 50.2 EMC + W
A + crop height ≤ V Max. 950 mm Max. 900
B + crop height ≤ H Max. 1,010 mm Max. 960
To Next Page
Loading...
