Safety
17
3
3.11 Warning and instruction stickers
Various warning and instruction notes are attached to the machine (for the posi-
tion at the machine, please refer to 3.10: Safety equipment at the machine, page
14).
The warning and instruction stickers are components of the machine. They must
not be removed or modified. Missing or illegible warning and instruction stickers
must be replaced immediately.
If new components are installed during repairs, the same warning and instruction
stickers that were on the original parts must be placed on the new parts.
3.11.1 Warning stickers
NOTICE
The correct warning and instruction notices can be obtained from the spare parts
service.
Read the operator's manual and warnings.
Read and observe the operator's manual and warning mes-
sages before commissioning the machine.
The operator’s manual explains in detail how to operate the
spreader and contains valuable information on operation,
care and maintenance.
Danger due to ejection of material
Danger of injury to the whole body caused by ejected spread-
ing material
Before commissioning, instruct all people to leave the hazard
zone (spreading range) of the machine.
Danger due to moving parts
Risk of body parts being cut off
It is prohibited to reach into the danger area of the rotating
spreading discs, the agitator or the drive shaft.
Switch off the engine and remove the key before carrying out
maintenance, repair and adjustment work.
Danger of crushing due to moving parts
Risk of body parts being cut off
It is prohibited to reach into the hazard zone of the metering
slide.
Switch off the engine and remove the key before carrying out
maintenance, repair and adjustment work.
To Next Page
Loading...
