Maintenance and service
117
10
10.6 Cleaning
We recommend cleaning the machine immediately after every use with a gentle
water jet in order to maintain its value.
To facilitate cleaning, fold up the protective grids in the hopper (see chapter 10.5:
Opening the protective grid in the hopper, page 115).
The following instructions must be observed for cleaning:
Clean the outlets and the area of the slide guide from below only.
Only clean oiled machines at washing points fitted with an oil separator.
When cleaning with high-pressure water, never aim the jet directly at warning
signs, electrical equipment, hydraulic components, and sliding bearings.
After cleaning, we recommend treating the dry machine, especially the coated
spreader vanes and stainless steel parts, with an environmentally friendly anti-
corrosion agent.
A suitable polishing kit can be ordered from authorised dealers for use in treating
rust spots.
10.6.1 Disassemble the dirt deflector
Use the adjustment lever on the machine. See figure 8.2, page 86.
Figure 10.11: Dirt deflector instruction sticker
1. Open the 3 quick release closures on the left- and the right-hand dirt deflector
2. Move the dirt deflector to the outside.
3. Put the dirt deflector down and store it in a safe place.
To Next Page
Loading...
