Rauch AXIS-M 30.2 - Instructions Regarding the Spreading Operation

Spreading operation 8
78
8.2 Instructions regarding the spreading operation
The intended use of the machine includes compliance with the operating, main-
tenance, and service conditions in accordance with the manufacturer specifica-
tions. Spreading operation therefore always includes preparation and
cleaning/maintenance.
 Carry out spreading operations in accordance with the sequence described
below.
Preparation
 Install the spreader at the tractor Page 46
 Close the metering slide
 Pre-set the mounting height Page 53
 Fill in the fertiliser Page 59
 Adjust the application rate Page 79
 Set the working width
- Select the correct spreading disc
- Adjust the drop point
Page 81
Page 84
Spreading
 Travel to the spreading location
 Check the mounting height
 Engage the PTO shaft
 Open the slider and start spreading
 Finish spreading operations, and close the
slide
 Disengage the PTO shaft
 Discharge residual material Page 99
Cleaning/maintenance
 Open the metering slide
 Remove the spreader from the tractor
 Cleaning and maintenance Page 107