Spreading operation 8
88
Normal spreading in or out of the headlands tramline
If you continue spreading in the field after headlands tramline spreading:
Move the border spreading unit TELIMAT out of the spreading area.
Figure 8.8: Normal spreading
[A] End of spreading fan when spreading in the headlands tramline
[E] End of spreading fan when spreading in the field
[T] Headlands tramline
[X] Working width
The metering slides open or close at different distances to the field border of the
headlands when travelling backwards and forwards.
NOTICE
If you use a GPS System (e.g. QUANTRON guide) as well as the operating unit
QUANTRON-E2 and/or QUANTRON-A for operating your machine, check that
the software of the operating unit includes the OptiPoint function.
The OptiPoint function calculates the optimal switching-on and switching-off
point for spreading in the headlands on the basis of the settings in the control
unit.
You can skip the information in the present paragraph since the OptiPoint
function assumes these settings.
Please observe the operator's manual for the corresponding control unit.
E
A
X
To Next Page
Loading...
