rav G3.150 - ERROR HANDLING, MAINTENANCE, AND DATA; Error Signals and Routine Maintenance

INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Page 83 of 91
16.0 ERROR SIGNALS
During wheel balancer operation, if wrong commands are given by the operator or device faults occur, an error
code may appear on the monitor screen.
Below is a troubleshooting chart.
Error code Description
2 Planned wheel speed not reached
3 Calibration overcoming
4 Wheel speed stability out of tolerance
5 Encoder calibration error
6 Encoder samples not sufficient
7 Chuck calibration error
8 Piezo calibration values out of tolerance
9 Wheel rotations not completed
10 Pneumatic chuck open
11 Incorrect gain calibration
12 Distance-diameter caliper value not released
13 Distance-diameter caliper value not released
14 Firmware error
15 Runout samples not sufficient
17 External data gauge enabled
27 Rotate the wheel to make a complete rotation
28 Piezo calibration error
29 Distance out of tolerance level
31 Distance-diameter caliper released
32 Parameters format incompatible
16.1 Error signals of printer kit (optional)
Error code Description
10022 Necessary bluetooth services are missing
10050 Bluetooth net inactivated
1297-M058-00
G3.150 - GP3.150 - G3.150S - GP3.150S - G3.150WS - GP3.150WS - G3.150WSPLUS - GP3.150WSPLUS - G3.150SA - G3.150WSA
RAVAGLIOLI S.p.A.