Install the Hawkeye® 2 RCM - Sprayer: RCM - Sprayer Installation 41
INSTALL THE HAWKEYE® 2 RCM - SPRAYER
FIGURE 12. ECU Cabinet Access for Hawkeye® 2
13. Remove the nut and washer from the round connector of the Hawkeye® 2 bulkhead cable.
14. Pass the round connector through the 1-1/2” hole drilled in the rear of the cabinet wall.
15. Reinstall the washer and nut hand tight from behind the ECU cabinet.
16. Replace the AGCO ECU and bracket removed previously using the original hardware.
To Next Page
Loading...
