Raven AGCO RoGator Hawkeye C Series - Introduction; Make and Model Compatibility; Section Spacing

CHAPTER
2
Introduction: Make and Model Compatibility 5
CHAPTER 2 INTRODUCTION
MAKE AND MODEL COMPATIBILITY
Hawkeye® 2 is a pressure-based product control system which allows for precise sprayer application over a range
of conditions and reduced spray drift. Each nozzle is controlled by an individual pulsing valve giving you a
consistent spray pattern as speed and conditions change.
Hawkeye® 2 is built on the ISOBUS communication platform which allows the system to work with most ISO
Universal Terminals (UTs) and task controllers, including the Viper® 4.
This manual is intended to provide installation instructions on the following equipment:
TABLE 1.
Compatible Equipment Information
SECTION SPACING
The information in the tables below are required for the machine configuration process on the Universal Terminal.
Refer to the Hawkeye® 2 Calibration and Operation Manual for machine assistance with system setup or
operation.
Make and Model
Nozzle
Spacing
Boom
Width
Nozzle Body Type Kit Number
AGCO RoGator C-Series
(RG900C, RG1100C,
RG1300C)
20”
132’
Wilger with ProStop-E 117-2005-100
Hypro 117-2005-104
120’
Wilger with ProStop-E 117-2005-101
Hypro 117-2005-105
100’
Wilger with ProStop-E 117-2005-102
Hypro 117-2005-106
90’
Wilger with ProStop-E 117-2005-103
Hypro 117-2005-107
19”
132’ Hypro 117-2005-108
120’ Hypro 117-2005-109
100’ Hypro 117-2005-110
15”
120’
Wilger with ProStop-E 117-2005-112
Hypro 117-2005-115
100’
Wilger with ProStop-E 117-2005-113
Hypro 117-2005-116
90’
Wilger with ProStop-E 117-2005-114
Hypro 117-2005-117
10” 120’ Hypro 117-2005-118