Carburetor Replacement
Removal/Installation Instructions
1. Use needle-nose pliers to carefully remove the speed regulator spring from the speed regulator lever. It may be
necessary to turn the lever by hand in order to remove the spring. Carefully remove the speed regulator pull rod from
the speed regulator lever. It may be necessary to turn the lever by hand in order to remove the rod.
2. Carefully slide the carburetor assembly off the mounting studs. Remove and discard the gray carburetor gasket.
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2014 Denver Global Products | RATO All rights reserved.
To Next Page
Loading...