Carburetor Replacement
Removal/Installation Instructions
3. Locate manifold spacer and slide of the mounting studs. It will be necessary to lift the spark plug wire to remove it.
Remove and discard the gray carburetor gasket. Ensure that no remnants of old gasket remain.
4. Locate new gray manifold spacer gasket, note correct orientation and slide onto the mounting studs, followed by the
manifold spacer. Slide both back against the engine. DO NOT USE MANIFOLD SPACER TO PUSH GASKET BACK
as it may damage the gasket. Push the spark plug wire back down onto the manifold spacer.
5. Carefully slide the new green gasket onto the mounting studs and ensure that small hole on top aligns correctly with
the manifold spacer. Slide new carburetor onto the mounting studs and push it back until it rests against the manifold
spacer.
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2014 Denver Global Products | RATO All rights reserved.
To Next Page
Loading...