8
CONSOLE FEATURES
IMPORTANT:
This Console requires selection of US (acres), SI [hectares], or TU
{1,000 sq. ft.} area; SP1 (wheel drive, etc.) or SP2 (radar) speed sensor; and
C-Sd (Standard Valve), C-F (Fast Valve), or C-FC (Fast Close Valve).
Console Revision can be determined by the
letter stamped in REV box on label.
Console Program can be determined by the
letter stamped in PGM box on label.
CE -Use like you do the CE key on a
calculator. This key is also used
to select the features listed in
IMPORTANT box above.
ENTER -Used only to enter data into
the Console.
Displays function and calibration
data.
Displays actual rate of application
and error messages.
Manual override control provides capability
for spot applications.
Selects manual or fully automatic control.
POWER -Turns Console OFF or ON. Turning
Console OFF does not affect data stored.
CALIBRATION KEYS -- Used to enter data into the
Console to calibrate the system.
BOOM CAL -- Length of Boom. Select Boom
number by using the
UP/DOWN arrow keys.
SPEED CAL -- Determined by Speed Sensor
METER CAL -- Meter Calibration Number
VALVE CAL -- Valve Response Time
RATE 1 CAL -- Target Application Rate
RATE 2 CAL -- Target Application Rate
TIME -- 24 Hour Clock (Military Time)
FUNCTION KEYS -- Used to Display Data
TOTAL AREA -- Total Area Applied
TOTAL VOLUME -- Total Volume Applied
FIELD AREA -- Field Area Applied
FIELD VOLUME -- Volume Applied to Field
DISTANCE -- Distance Traveled
SPEED -- Speed of Vehicle
VOL/MIN -- Volume Per Minute
DATA MENU -- Printer Option
063-XXXX-XXX
To Next Page
Loading...
Need help?
General
