26
13. DECIMAL SHIFT
The DECIMAL SHIFT feature is used to increase system accuracy at low application
rates. Shifting of the decimal point is done during the entry of METER CAL. After
entering METER CAL mode, depress the decimal shift key labelled , enter
the meter calibration constant number, and depress
. The sequence to unshift
the decimals while in METER CAL is to enter the meter calibration constant number
and depress
. The following table illustrates how shifting the decimal point
can increase system accuracy.
DECIMAL PLACE LOCATIONS
US METRIC TURF
UNSHIFT SHIFT UNSHIFT SHIFT UNSHIFT SHIFT
RATE DISPLAY 000.0 00.00 0000 000.0 00.00 00.00
RATE 1 CAL 000.0 00.00 0000 000.0 00.00 00.00
RATE 2 CAL 000.0 00.00 0000 000.0 00.00 00.00
TANK VOLUME 0000 000.0 0000 000.0 000.0 000.0
TOTAL AREA 000.0 000.0 000.0 000.0 0000 0000
TOTAL VOLUME 0000 000.0 0000 000.0 000.0 000.0
FIELD AREA 000.0 000.0 000.0 000.0 0000 0000
FIELD VOLUME 0000 000.0 0000 000.0 000.0 000.0
VOL/MINUTE 0000 000.0 0000 000.0 000.0 000.0
AREA/HOUR 000.0 000.0 000.0 000.0 0000 0000
RATE +/- 000.0 00.00 0000 000.0 00.00 00.00
LOW TANK LEVEL 0000 000.0 0000 000.0 000.0 000.0
LOW VOL/MIN 0000 000.0 0000 000.0 000.0 000.0
When entering RATE 1 CAL and RATE 2 CAL, remember that 2 GPA [20 lit/ha]
is entered as 2.0 [20.0] when unshifted and 2.00 [20.00] when shifted.
To Next Page
Loading...
