18
2. OTHER DISPLAY FEATURES
1) To display TOTAL AREA covered, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
2) To display TOTAL VOLUME sprayed, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
3) To display FIELD AREA covered, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
4) To display FIELD VOLUME sprayed, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
5) To display DISTANCE (feet) [meters] traveled, momentarily depress key
labelled
. To "zero out" this total at any time, enter a "0" in this key.
6) To display SPEED, momentarily depress key labelled
7) To display VOL/MIN, momentarily depress key labelled
8) To display AREA/HOUR, momentarily depress key labelled . This is an actual
calculation of AREA/HOUR at the present speed you are going. It is not an average
over a period of time.
9) To display US, SI, or TU; SP1 or SP2; LI, GR1, or GR2; and C-Sd, C-F, or C-FC after
being selected, depress key labelled
.
3. SELF TEST FEATURE
SELF-TEST allows speed simulation for testing the system while vehicle is not
moving. Enter the simulated operating speed in key labelled
. If 6 MPH
[10 km/h] is desired, enter 6.0 [10.0]. Verify SPEED by depressing key
labelled
. The SELF-TEST speed will clear itself when motion of vehicle
is detected by the Speed Sensor. A SPEED CAL value of 900 [230] or greater is
recommended when operating in this mode.
NOTE: To prevent nuisance clearing of self-test speed, disconnect speed
connector on back of Console when Radar Speed Sensors are used.
To Next Page
Loading...
