25
DISPLAY DESCRIPTION
DISPLAY SMOOTHING Turns display smoothing ON or OFF. Selecting display smoothing ON
means the RATE displays target rate when actual rate is within 10% of target
rate. Actual rate is displayed if unit does not reach deadband within 10
seconds. Display smoothing OFF means RATE displays actual rate at all
times.
TIME Set the current time of day.
MONTH Set the current month.
DAY Set the current date.
YEAR Set the current year (two digits).
DAYS WAIT Set the number of days after console is powered off before console goes
into very low power consumption mode and time settings are lost.
DATALOCK Prohibits the entry of data without first entering the DATA-LOCK code. Enter
a 4-digit security code or "0" to disable.
PGM UPDATE Press to initilize console update procedure via serial port. Requires
programming software, PC with null modem cable, and replacement firm-
ware. (See Appendix 12)
PGM REV LEVEL Displays console software program number and revision level.
ZERO SPEED SHUTOFF Enable or disable Low Speed Shutoff feature. If enabled, product control will
be shut off if speed drops below 0.7 MPH [km/H] in automatic mode. The
Master switch must be cycled OFF and then ON to restart the system. If a
constant speed greater than 0.7 MPH [km/H] is not attained within 10
seconds, the low speed shutoff will be enacted again.
SUBMENU: CAN
BOOM SENSE AND Installed onboard with SCS 4600.
SPD NODE
BOOM CONTROL NODE Enable or disable CAN communication with CAN Boom Control Node.
Program and revision of node will appear if installed.
PRODUCT CONTROL Installed onboard with SCS 4600.
NODE 1
PRODUCT CONTROL Enable or disable CAN communication with CAN Product Control Node #2.
NODE 2 Program and revision of node will appear if installed.
PRODUCT CONTROL Enable or disable CAN communication with CAN Product Control Node #3.
NODE 3 Program and revision of node will appear if installed.
READDRESS CONTROL Reconfigure Product Control Node Order. See PROCEDURE TO READ-
NODES DRESS CAN PRODUCT CONTROL NODES in CAN Applications Section.
To Next Page
Loading...
Need help?
General
