22
LIQUID AND GRANULAR
APPLICATIONS
5. DATA MENU
The following are brief descriptions of features available under the DATA MENU key. There are four
submenus (Serial, Product, Console, and CAN) included in the Data Menu. To access
options under each category, use keys and . To advance to the next category, press
the key. Use to toggle selections or to input data.
SUBMENU: SERIAL
DISPLAY DESCRIPTION
DATA LOGGER Enables or disables data logging through serial port. Must have Trigger Value
and unit selected to enable.
FIELD REFERENCE Allows user to enter up to a four-digit number to represent a field. Field
reference is included in field begin and field end pages and the data logger
time/date string.
GPS BAUD RATE Select between 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200
baud for communicating with GPS receiver.
VARIABLE RATE Enable or disable audible and visual alarm upon a variable rate change.
CHANGE ALARM When ON, alarm sounds 4 long beeps when a rate calibration number is
changed via the serial port using a valid change request data string.
TRIGGER VALUE Used in data logging mode. The trigger determines how often data (See data
communication string formats) is sent to the serial port. The trigger may be
either in feet [meter] or seconds. Data Logger functions will not work until
trigger value is nonzero.
TRIGGER UNITS Used in data logging mode. The trigger unit is selectable between feet
[meters] or seconds.
DATA DIRECTION Select between Saving Data To Flashcard or Passing Data Through Com
Port.
COM 1 STOP BITS Select between one or two stop bits for communicating with GPS receiver.
DATALOG MODE Select between logging GPS and Console Data (Master Switch Pauses Log)
or GPS Data only (Continuous Log).
SUBMENU: PRODUCT (PAGE 1)
BOOM SELECT This feature allows the user to assign specific booms to be used only with
certain products. These products will only be enabled when the assigned
booms are turned on. Note that the system plumbing must accomodate
selections made for this feature. Once entering boom select mode, use the
CE key to toggle between products and keys 1 through 0 to toggle the boom
selection ON or OFF for Booms 1-10 respectively. The boom status display
indicator will show the selected booms for the active product. All booms are
initially selected ON for each product. Press ENTER to exit boom select
mode.
To Next Page
Loading...
Need help?
General
