23
2. OTHER DISPLAY FEATURES
1) To display TOTAL AREA covered, momentarily depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
2) To display TOTAL VOLUME applied, momentarily depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
3) To display FIELD AREA covered, momentarily depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
4) To display FIELD VOLUME applied, momentarily depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
5) To display DISTANCE (feet) [meters] traveled, momentarily depress key labelled
. To
"zero out" this total at any time, enter a "0" in this key.
6) To display SPEED, momentarily depress key labelled
7) To display VOL/MIN, momentarily depress key labelled
8) To display AREA/HOUR, momentarily depress key labelled
This is an actual calculation of AREA/HOUR at the present speed you are going. It is not an average
over a period of time.
9) To display selections after US, SI, or TU; SP1 or SP2; and C-Sd, C-F, C-FC, or C-P have been
selected, depress and continue to hold
. Selections will alternate in the display window.
3. SELF TEST FEATURE
SELF-TEST allows speed simulation for testing the system while vehicle is not moving. Enter the
simulated operating speed in key labelled
. If 6 MPH [10 km/h] is desired, enter 6.0 [10.0].
Verify SPEED by depressing key labelled
. The SELF-TEST speed will clear itself when
motion of vehicle is detected by the Speed Sensor. A SPEED CAL value of 900 [230] or greater is
recommended when operating in this mode.
NOTE: To prevent nuisance clearing of self-test speed, disconnect speed connector on
back of Console when Radar Speed Sensors are used.
To Next Page
Loading...
