Raychem C910-485 - 4.2 Console Mode Menus: High Temp Alarm Enable; 4.2 Console Mode Menus: Hi TS Enable;Disable Keystrokes

nVent.com | 27
4.2.9 High Temperature Alarm: Enable (Hi TS 1 and Hi TS 2)
Purpose
This allows the user to enable or disable the high temperature alarm
for temperature sensor number 1 and 2. When enabled, high limit
cutout feature will force the controller output off if the
temperature
reading exceeds the HIGH
ALARM temperature setting. This is a non-
latching condition, so once the reading drops below the HIGH
temperature ALARM
setting, the controller will resume normal
operation.
Alarm time delay filter is factory set at 15 minutes.
Setting/Range
Enable or disable
Factory Default
Disable