Raychem C910-485 - 4.2 Console Mode Menus: Auto-Cycle Enabling; 4.2 Console Mode Menus: Auto-Cycle Enable;Disable Keystrokes

nVent.com | 43
4.2.24 Auto-Cycle: Enabling
Purpose
The autocycle function applies power to the heating cable circuit for
approximate 10 seconds
at the selected interval. It is used to test the
integrity of the heating
cable circuit.
Note: Although the autocycle function helps monitor the
functionality of the heating cable circuits it does not eliminate the
need for preventive maintenance as detailed in the heating cable
operating manuals.
Setting/Range
Enable or disable
Factory Default
Disable