Raycus RFL-C4000S - The Waveform Command Definition

Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL- RFL-C4000S
31
Figure 15 Interface diagram of programming setting
Click the "Refresh List" button, and the software will automatically list the number of saved
waveforms.Select the waveform number, the program will automatically list the original
waveform list.Green indicates that the bar has a program, and white indicates that the bar is empty.
Select the pre-edited waveform number, select the command under command type, write the
command and click "Add". After editing all the commands, click "Write laser". Click "Refresh
List" again, and the new waveform number will turn green, indicating that writing is successful.
Figure 16 Laser waveform command reading and editing
4.8.3 The Waveform Command Definition