7 Operation
7.1 Before commissioning
Check the following points before commissioning:
•
Completeness and technically flawless condition of the machine and safety devices.
•
Order and cleanliness at the workplace.
•
Cleanliness of optical components (free of dust and dirt).
•
Activated exhaust system.
•
Complete electrical installation.
•
Correct input voltage of the electrical installation.
•
Environmental conditions according to technical specification.
•
Compliance with all laser safety regulations and measures.
•
Fulfill and compliance with all laser safety requirements.
If errors or functional deviations should occur during the inspection of the listed points, the machine is not
considered to be safe to operate and must not (no longer) be put into operation until the cause has been
clarified!
If you have any questions, contact our experienced Technical Support in your local area.
7.1.1 Installation and replacement of the laser source
Caution
The laser source must be installed and replaced by a technician.
Warning Current
High voltage can cause serious injury or even death.
The laser source may only be replaced and installed by trained, qualified and authorized
personnel.
Observe general electrotechnical safety regulations.
Disconnect the power supply before opening. Wait at least 30 minutes before starting work on
the laser source.
7.2 Software
For information on how to use the software, please read the accompanying software manual, which you will
find on the storage medium provided.
ENGLISH (Translation)
07/2021
49 / 83
To Next Page
Loading...
