Rayjet R500 - Relocation of the machine

5. Remove the machine from the crate and position it
in the desired location.
6. Remove the packing material.
7. The machine must be set up and installed by a
technician (see installation instructions R500).
5.8 Relocation of the machine
Steps:
1. Switch off the machine.
2. Disconnect the power cable.
3. Remove the exhaust system.
4. Reposition the machine (e.g. with auxiliary equipment if necessary) and place it on a level, clean floor.
5. Adjust the machine.
6. Initial commissioning of the electrical system.
7. Carry out function test.
ENGLISH
ENGLISH
40 / 81