System Components Daily Weekly Half-yearly Yearly
Cleaning drawer ✓✓
Vent slots of exhaust box.
(inside the machine)
✓✓
Entire working area.
General cleaning.
✓
Vent slots (backside of the maschine) ✓✓
Spindles Clean and
grease.
Cover of the laser source and housing. ✓
✓ ✓ Check and clean whenever required.
✓ Clean whenever required.
Notice
In order to ensure the maximum availability and lifetime of the system, we recommend that you
regularly check the filter, ventilation and exhaust slots and keep the surrounding area clean. A
visual inspection of the lenses is likewise recommended before switching on the system.
8.3 Cleaning
8.3.1 Machine
1. Move the working table into a position in which it is easiest for you to clean the surface with a window
cleaning agent and paper towels.
2. Switch off and disconnect the machine from the mains.
3. Open the transparent acrylic top lid and front panel.
4. Thoroughly remove all loose dirt particles and deposits in the interior of the machine (e.g. with a vacuum
cleaner or broom).
5. Clean the air guide plate and vent slots of the exhaust box inside the machine using a dry or damp cloth
or brush.
6. Clean the cover of the laser source and vent slots at the back of the machine using a dry or damp cloth.
7. Clean the transparent acrylic top lid using a dry or slightly damp cotton cloth. Do not use paper towels as
they could scratch the acrylic.
ENGLISH
ENGLISH
60 / 81
To Next Page
Loading...