8.3.5 Motion system
Information
To ensure a long service life of the machine with high quality and performance, you should
spend a few minutes per week (depending on the environment) on cleaning.
After cleaning the rails it is necessary to clean the table, the interior of the machine and the
cleaning drawer.
X-axis rail cleaning
1. Clean the entire length of the x-axis rail with a
cleaning cloth and a cotton swab. Use some
cleaning foam (Trotec) or a similar mild solvent to
clean the bearing.
Notice
After cleaning is the ideal time to lubricate the axles.
Y-axis rail cleaning
1. Clean the entire length of the y-axis rails with a
cleaning cloth.
Perform this procedure on both sides.
ENGLISH
ENGLISH
64 / 81
To Next Page
Loading...