2. Adjust the machine to the correct height with the
height-adjustable feet on the machine.
3. Level the x-axis using a spirit level. Set the
machine to the correct height using the height-
adjustable feet on the machine.
7.1.1 Installation and replacement of the laser source
Caution
The laser source must be installed and replaced by a technician.
Warning Dangerous electrical voltage
High voltage can cause serious injury or even death.
The laser source may only be replaced and installed by trained, qualified and authorized
personnel.
Observe general electrotechnical safety regulations.
Disconnect the power supply before opening. Wait at least 30 minutes before starting work on
the laser source.
7.2 Software
For information on how to use the software, please read the accompanying software manual, which you will
find on the storage medium provided.
ENGLISH
ENGLISH
48 / 81
To Next Page
Loading...