Raymarine C120 - Monitoring data and engines; Navtex

8 C-Series Display New Features
Note: When the compass bar is displayed the transducer icons remain visible in the top-right
section of the screen.
Compass bar setup
The compass bar is set to open in heading mode. To change this setting, press the
MENU button and go to the Databar Setup menu where you can select either Heading
or COG.
Note: If MOB is activated while the compass bar is open, the compass is replaced with the
MOB toolbar. The compass bar returns when you cancel the active MOB.
3.2 Graphical engine data
You can now display engine tilt and trim data, and data for up to four engine-driven
electricity generators (gensets). You may need to set up a new page (or modify an
existing page set) for this data as an engine application window is not included in the
preconfigured page sets.
To set up an engine data page
1. Press and hold the PAGE button.
2. Select the page set you want to edit by pressing its corresponding softkey.
3. Highlight your preferred page layout and press OK.
4. In the application list, highlight engine and press OK.
Refer to the C-Series Reference Manual for more details on setting up page sets.
Engine tilt and trim
To display engine tilt or trim data:
1. Press the MENU button to open the Setup screen.
2. Select Panel Setup Menu.
3. Select a configuration.
4. Press the SELECT DATA… softkey.
5. In the Data Groups window, select Engine.
6. Select Engine Tilt or Trim Tabs.
Genset data
To display genset data:
1. Press the SELECT DATA… softkey.
2. In the Data Groups window, select Genset.