Raymarine C120 - To Change the Number of Gensets

Chapter 3: Graphical Data 9
For a list of the data you can display for each genset, see Table 3-2, Genset Data
Options
.
To change the number of gensets
The default number of gensets is one. You can configure the unit to display data for up
to four gensets:
1. Press the MENU button.
2. Select Panel Setup Menu…
3. Select Number of Gensets.
Table 3-2: Genset Data Options
Data Data type Data range
Speed Numeric or gauge —
Total hours Numeric —
Coolant temperature Numeric or gauge with num-
bers
0–150ºC
0–300ºF
Fuel temperature Numeric or gauge 0–150ºC
0–300ºF
Oil pressure Numeric or gauge with num-
bers
0–100 PSI
0–7 bar
0–750 KPa
Fuel rate Numeric —
Battery voltage Numeric or gauge with num-
bers
8–24V
Average line voltage Numeric or gauge with num-
bers
8–24V
Average AC frequency Numeric —
Status Text —
Load Numeric or gauge 0–100%