Important information i
Important Information
Intended use
The C-Series display unit can be used in GPS-based or marine radar-based navigation
systems on non-IMO/SOLAS class leisure vessels or small workboats.
This handbook tells you how to operate and maintain the C-Series display effectively.
For information on system integration and how to install the unit, refer to the C-Series
Installation Guide supplied with the display.
Safety notices
WARNING: Navigation Aid
This device is intended to be used as an aid to navigation. Its
accuracy can be affected by many factors, including equipment
failure or defects, environmental conditions and incorrect
handling or use. It is the user’s responsibility to exercise
common prudence and navigational judgement. This device
should not be relied upon as a substitute for such prudence and
judgement.
WARNING:Product installation
This equipment must be installed in accordance with the
instructions in the C-Series System Installation Guide. Failure
to do so could result in poor product performance, personal
injury and/or damage to the vessel.
WARNING:High voltage
The display unit and scanner unit contain high voltages.
Adjustments require specialized service procedures and tools
only available to qualified service technicians - there are no
user serviceable parts or adjustments. The operator should
never remove the display unit cover or attempt to service the
equipment.
WARNING:Electromagnetic energy
The radar scanner transmits electromagnetic energy. Ensure
that the scanner has been installed according to the
recommendations given in the relevant scanner handbook.
Avoid looking directly at the antenna.
To Next Page
Loading...
