Chapter 2: Installation 2-3
Surface Mounting
Refer to Figure 2-1 :
1. Select a suitable area which allows access to the underside of the
mountingsurface for fixingand, using the templatesupplied in
this document, carefully drill the two 6mm (0.25in) fixing holes
marked.
2. If the cableis to passthrough the mountingsurface drill the 6mm
(0.25in)or 19mm (0.75in)centre hole depending onwhether the
plugis to pass through the surfaceor not.
If the cable is to exit fromthe side of the GPS Receiver above the
mounting surface, remove thetwo plastic tabs (1) obstructing the
cable channel.
Note: Failure to remove the plastic tabs from within the cable chan-
nel could result in cable damage.
3. Screw the supplied brassstuds (2)into the underside of theGPS
Receiver.
4. Stickthesuppliedgasket(3)tothemountingsurfaceensuringthat
the holes matchand pass the cable throughthe centre hole or the
cable exit channel.
5. Carefully position the GPS Receiver, passing the studs through
the holes in themounting surface and secure to the mounting sur-
face using the thumb nuts provided(4).
81170_2.BOOK Page 3 Thursday, July 19, 2001 2:36 PM
To Next Page
Loading...
