2-4 Raystar 120 GPS Receiver
Figure 2-1: Surface Mounting Arrangement
Pole Mounting
Refer to Figure2-2 :
1. Screwthepolemountbasetoasuitablepoleorrailmountbracket,
having an industry standard 1in14TPI thread, untilsecure.
2. Pass the cable through the centre hole of the pole mountbase (A)
or through the cable exit hole alongside thecentre hole (B)or
insert the cable into the side exit channel (C).
3. Check the cableis positioned correctly and secure the GPS
Receiver to the pole mount base using the two screws provided.
If the cable isto exitfrom the side of the GPS Receiverthrough
the side channel,remove the two plastictabs(1) obstructing the
cablechannel.
Note: Failure to remove the plastic tabs from within the cable chan-
nel could result in cable damage.
D4725_1
1
2
3
4
2
3
4
Top view
Underside view
81170_2.BOOK Page 4 Thursday, July 19, 2001 2:36 PM
To Next Page
Loading...
