The tool widens the gap in the split ring, enabling the split ring to be pushed further back onto
the connector in the following step.
Important:Alwaysusethesuppliedtoolwhenattachingthesplitring.Thesplitringmaybecome
overstretchedandbreakifyoutrytoattachitwithoutusingthetool.
4.Usethetooltogentlyleverthesplitringoverthemouldingontheconnectoruntilitsnapsinto
positionapproximately0.5cmfurtherbacktowardsthecable-endoftheconnector.
Y ou can now remove the tool. The split - ring stays in position on the connector, but rotates freely.
5.SlidetheO-ringovertheendoftheconnector,andensurethatitisseatedsquarelyagainstthe
connectormoulding,adjacenttothesplit-ring.
16
To Next Page
Loading...
