Chapter 2: Advanced operation 27
2.3 How do I display boat data?
Use the
disp
button to sh ow ‘data pages’ of SeaT alk or NMEA data:
1. Press
disp
to access the first data page , and press it again to cycle throug h
each data page in turn:
• when you cycle past the last data page, the display returns to the current
SmartPi lot mode screen (for example, AUTO).
• 4 dat a pages are set in the facto ry as a default (see dia gram): within User
setup yo u can select up to 15 pa ges and control the info rmation they dis
play (see
SmartPilo t Comm issioning Guide
).
Notes: (1)
If the SmartPilot sy stem cannot obtain the requir ed information, the data
page will show dashes ins tead of a value.
(2)
The directio ntosteer arrows relate to the data pag e information.
(3)
Most data pages show repeated data so you cannot adjust them: the
exceptions are the
RESPONSE
and
RUDDER GA IN
data pages ,
which you can adjust us ing the
1
and
+1
button s
Can I display Waypoint names?
If way points have been given names , the SmartPilo t controller will display them
on the Cro ss T rack Error (
XTE
), Bearing T o W aypoin t (
BTW
) and Distance T o
Waypoint (
DTW
) data pages:
• way point names of five characters or less are di splayed together with th e
page na me (as shown by screen
A
below).
• way point names of more than five characters alternate with the page name
(as shown by screen
B
below).
D5455-3
Autopilot mode
Data page 1
Data page 3
Data page 4
Data page 2
Default data pages
Press for 1 sec to
return to previous
data page
81283_1.book Page 27 Monday, October 2, 2006 2:03 PM
To Next Page
Loading...
