Raymarine SmartPilot Series - Page 48

38 S1 Wheel and Tiller Pilots Operating Guide
4. Check that the wheel sti ll moves freely with the clutch off .
Note: If th e wheel does not mo ve fr eely, r educe th e clutch t ension by t urning the clutch
knob 2 clicks anticlockwise and check again
5. Check the drive’ s operation with the clutch engaged.
T his procedure is usual ly sufficient to correct a slipping or dragging dr ive belt. In
some cases , however , you may need to repeat the steps to adjust the clutch
further.
Replacing the belt
The drive belt is designed to be user serviceable . If there is insufficient adjustment
to cure a slip ping clutch, or if the drive belt is damaged in any way (if it is brok en,
frayed or stretc hed), you shoul d replace the drive belt. Y ou can obtain a
replacem ent belt from any Ray marine dealer (part numb er A18083). F itting
instruc tions a re su pplied with th e belt.
User serviceable parts
Y ou can obtain the following 4000 mk2 wheel drive spare parts from yo ur
Raymarin e dealer:
2
3
1
Loosen the screw
(2 turns)
Tighten the screw
(2 turns)
To tighten
the clutch
(4 clicks)
To loosen
the clutch
(4 clicks)
Adjusting the clutch
Clutch knob
screw
Clutch knob
D5349-2
81283_1.book Page 38 Monday, October 2, 2006 2:03 PM