Raymarine SmartPilot X-5R - Autolearn Procedure

Chapter 3: Commissioning & Setup 41
AutoLearn procedure
1. If you are not already in Seatrial calibration:
i. From Standby mode, hold down
standby for 2 seconds, then press disp twice
to see the
SEATRIAL CAL screen.
ii. Press
auto to enter Seatrial calibration.
iii. Press
disp four times to see the AUTOLEARN screen.
2. In Seatrial calibration, press
disp as necessary, until the AUTOLEARN screen is
displayed.
At least 0.2
5 nm (500 m) of clear sea space
At least 0.04 nm (100 m)
of clear sea space
D11543-1
Typical non-planing vessel at 6 kts
Wind
At least 1 n
m (2000 m) of clear sea space
At least 0.25 nm (500 m)
of clear sea space
D11544-1
Typical planing vessel at 20 kts
Wind