Raymarine SmartPilot X-5R User Manual

60 SmartPilot X-5R Drive Installation and Setup Guide
3. The screen will then show an ARE YOU SURE message. Either:
• Press
auto to cancel the reset
or
•Press
+1 again to select YES and reset the SPX-5R Drive system.
4. You will then see the
CAL LOCK screen:
• Hold down
standby for 2 seconds to save the new default settings, then turn
the SPX-5R Drive system computer power off and back on
If you reset the system parameters, you must carry out the SPX-5R Drive
system commissioning process before using the SPX-5R Drive system again.
4.5 System defaults
Vessel type Factory
Defaults
Displacement Semi-
Displace-
ment
Planing Stern Drive Work Boat
Calibration Lock OFF OFF OFF OFF OFF OFF
Vessel Type 0 DISPLACE SEMI
DISPLACE
PLANING STERN
DRV
WORK
BOAT
Drive Type 3 4 4 4 3 4
Rudder Alignment 0 0 0 0 0 0
Rudder Limit 30 30 30 20 20 30
Rudder Gain 4 5 4 4 4 5
Counter Rudder 4 3 5 5 5 2
Rudder Damping 2 2 2 2 2 3
AutoTrim 2 2 3 3 3 2
Response: 5 5 5 5 5 5
Turn Rate Limit 7 7 7 7 5 7
Off Course Angle 20 20 20 20 20 20
Power Steer
(Joystick)
OFF
Cruise Speed 8 8 8 8 20 8
Latitude 0 0 0 0 0 0
Autopilot Reset OFF OFF OFF OFF OFF OFF

Raymarine SmartPilot X-5R Specifications

General

Brand	Raymarine
Model	SmartPilot X-5R
Category	Marine Equipment
Language	English