Chapter 4: SPX-5 Wheel system settings 57
System reset
CAUTION: Losing settings at system reset
Do NOT carry out a System RESET unless advised to do so by a
Raymarine dealer. If you complete a reset you will lose the SPX-5
Wheel system calibration settings. You will then need to repeat the
SPX-5 Wheel system commissioning process.
Carrying out a System reset will reset User calibration, Seatrial calibration and Dealer
calibration settings to their default values.
Note:
the Display calibration settings will not change, as these are stored in each individual con-
troller
To carry out a system reset:
1. Select the System reset (
RESET
) screen in Dealer calibration.
2. Press
+1
then press
auto
.
3. The screen will then show an
ARE YOU SURE
message. Either:
•Press
auto
to cancel the reset
or
•Press
+1
again to select YES and reset the SPX-5 Wheel system.
4. You will then see the
CAL LOCK
screen:
• Hold down
standby
for 2 seconds to save the new settings, then turn the
SPX-5 Wheel system computer power off and back on.
If you reset the system parameters, you must carry out the SPX-5 Wheel
system commissioning process before using the SPX-5 Wheel system again.
4.5 System defaults
Parameter Defaults Parameter Defaults
Calibration Lock OFF Turn Rate Limit 7
Vessel Type SAIL BOAT Off Course Angle 20
Drive Type 3 AutoTack Angle 100
Rudder Alignment 0 Gybe Inhibit ON
Rudder Limit 30 Wind Type APP
Rudder Gain 2 Wind Trim 5
Counter Rudder 2 Power Steer (Joystick) OFF
Rudder Damping 2 Cruise Speed 8
AutoTrim 1 Latitude 0
Response: 5 Autopilot Reset OFF
87074_2.book Page 57 Wednesday, November 21, 2007 3:55 PM
To Next Page
Loading...
